| dual-band-radio-band |
slot-id band toband alternative-choice |
Configures the 802.11 dual-band radio's current band i.e 2.4GHz/5GHz |
| lan-port-config-enable |
port-id mode poe-enabled power-level-id port-config-type alternative-choice |
AP LAN port configuration |
| set-ap-admin-state |
mode alternative-choice |
Disable/Enable AP admin state |
| set-ap-antenna-band-mode |
band-val alternative-choice |
Configure antenna band mode |
| set-ap-cleanair |
mode slot-id alternative-choice |
Configures clean air functionality on radio band of access point |
| set-ap-controller |
mode controller-name index ipaddr alternative-choice |
Configures controller information in AP |
| set-ap-country |
country-string alternative-choice |
Configure the country of operation |
| set-ap-led-brightness-level |
led-brightness-level alternative-choice |
Configure the LED brightness level |
| set-ap-location |
location alternative-choice |
Configure AP location |
| set-ap-mode |
clear-mode mode alternative-choice |
Configures AP mode |
| set-ap-monitor-mode-chnl-optimize |
mode alternative-choice |
Channel scanning optimization for AP |
| set-ap-name |
name alternative-choice |
Configure a new AP name |
| set-ap-slot-admin-state |
mode slot-id band alternative-choice |
Configure admin state of AP slot |
| set-ap-slot-antenna-mode |
antenna-mode slot-id alternative-choice |
Configures the antenna mode of the AP |
| set-ap-slot-ext-antenna-gain |
external-antenna-gain slot-id band alternative-choice |
Configures the external antenna gain of AP |
| set-ap-slot-phy-ht-chan |
chan slot-id band alternative-choice |
Configures static channel on a radio interface of AP |
| set-ap-slot-phy-ht-customize |
slot-id band alternative-choice |
Enables auto channel selection for a radio band of access point |
| set-ap-slot-tx-power-customize |
mode slot-id band alternative-choice |
Enables auto RF on a slot |
| set-ap-slot-tx-power-level |
tx-power-level slot-id band alternative-choice |
Modify transmit power level of an AP slot (band) |
| set-ap-vlan-tag |
vlan-id alternative-choice |
Configures VLAN tagging for non-bridge AP |
| set-lrad-led-state |
ledstate alternative-choice |
Configure LED state for Cisco AP |